Theses most similar to Thermal analysis of an oil and R-22 cooled compressor motor (Leung, Patrick Cheong-Yu; 1994) read it
Forced convective heat transfer to supercritical water in micro-rocket cooling passages
Faust, Adriane (Adriane Jean), 1976- (2000)
- Advisor: Jack L. Kerrebrock
- Department of Aeronautics and Astronautics
Steam condensation in the presence of noncondensable gases under forced convection conditions
Hasanein, Hisham A. (Hisham Abdel-Moneim) (1994)
- Advisor: Michael W. Golay William W. Hoga
- Department of Nuclear Engineering
Film boiling on the inside of vertical tubes with upward flow of the fluid at low qualities
Dougall, Richard Stephen (1963)
- Advisor: Warren M. Rohsenow
- Department of Mechanical Engineering
Design of an experimental loop for post-LOCA heat transfer regimes in a Gas-cooled Fast Reactor
Cochran, Peter A. (Peter Andrew) (2005)
- Advisor: Hejzlar, Pavel
- Department of Nuclear Engineering
- Advisor: Peter Griffith
- Department of Mechanical Engineering
An investigation of instantaneous heat transfer during compression and expansion in reciprocating gas handling equipment
Faulkner, Henry B (1983)
- Advisor: Joseph L. Smith, Jr.
- Department of Mechanical Engineering
Design of test apparatus to analyze two-phase refrigerant flow distribution for furnace coil applications
Smith, Heather Gerallyn (1994)
- Advisor: Peter Griffith
- Department of Mechanical Engineering
- Advisor: Peter Griffith
- Department of Mechanical Engineering
Shaft efficiency measurements of a fully scaled turbine in a short duration facility
Keogh, Rory (Rory Colm), 1968- (1998)
- Advisor: Gerald R. Guenette
- Department of Aeronautics and Astronautics
Experimental investigation of variables affecting regenerative pump performance
Santalo-Cortina, Miguel Angel (1954)
- Advisor: William A. Wilson
- Department of Mechanical Engineering