Theses most similar to Achieving mass customization in the Boeing Wire Responsibility Center (Napier, Matthew Kirk, 1968-; 2000) read it
Modeling design rework in a product development process
Bromberg, Matthew F. (Matthew Fox), 1970- (2000)
- Advisors: Eppinger, Steven D; Stephen C. Graves
- Department of Mechanical Engineering
Alternate methodology for generation and use of key characteristics
Seubert, Richard E. (Richard Eugene) (1996)
- Advisors: Charles Fine; Dr. Daniel E. Whitney
- Department of Mechanical Engineering
Case studies in DSM : utilizing the Design Structure Matrix to improve New Product Introduction
Go, Julie W (2007)
- Advisors: Dr. Daniel E. Whitney; Sara Beckman
- Engineering Systems Division
Analysis of the effect of planning/design phase factors on rework
Liu, Michael W. (Michael Wen-Tseng) (2008)
- Advisors: Dan Frey; David Simchi-Levi Roy Welsc
- Engineering Systems Division
- Advisors: David Simchi-Levi Roy Welsc; Eric Rebentisch
- Department of Mechanical Engineering
Design for manufacturing analysis on the Small Unmanned Ground Vehicle
Yu, Ada (Ada Cheuk Ying) (2008)
- Advisors: Dr. Daniel E. Whitney; John H. Lienhard, V, Roy E. Welsch
- Department of Mechanical Engineering
Module based configuration definition to enable design re-use and manufacturing system simplification in the commercial aircraft industry
Koszarek, Albert E. (Albert Ernst) (1996)
- Advisor: Eugene E. Covert
- Department of Aeronautics and Astronautics
- Advisors: Eric S. Rebentisch; Sheila E. Widnall
- Department of Aeronautics and Astronautics; Technology and Policy Program
- Advisors: Brian L. Wardle; David Simchi-Levi Roy Welsc
- Department of Aeronautics and Astronautics
A methodology for implementing total productive maintenance in the commercial aircraft industry
Hamacher, Eugene C. (Eugene Carl) (1996)
- Advisors:
- Department of Electrical Engineering and Computer Science